Barium cobaltite nanoparticles: Sol-gel synthesis and characterization and their electrochemical hydrogen storage properties

The study of the effect of different chelating agents in the Pechini method on the morphology has been a promising strategy that can be used for practical tuning of the nanoparticle's morphology and hence the electrochemical hydrogen storage capacity. In the current study, the conventional Pechini sol-gel approach was used to prepare the Ba₂Co₉O₁₄ nanoparticles as a novel hydrogen storage material. The X-ray diffraction investigation approved the formation of Ba₂Co₉O₁₄ with a Hexagonal crystal structure for all of the synthesized samples. The scanning electron microscopy (SEM) revealed when citric acid was used as a chelating agent, nanoparticles with finer and more uniform morphology were obtained rather than other chelating sources. The transmission electron microscopy (TEM) showed in the presence of citric acid; the size of the synthesized nanoparticles was between 14 and 24 nm. According to the Diffuse Reflectance Spectroscopy (DRS) analysis, the calculated bandgap of synthesized nanoparticles was approximately 3.2 eV, which indicates that synthesized nanoparticles were semiconductors in essence. The electrochemical hydrogen adsorption/desorption results showed that the sample synthesized by the citric acid has an enhancement in electrochemical hydrogen storage of approximately 800 mAh/g after 15 cycles.     

Design and computational analysis of a metal hydride hydrogen storage system with hexagonal honeycomb based heat transfer enhancements-part A

In this study, design and performance analysis is carried out for a 10 kWh metal hydride based hydrogen storage system. The system is equipped with distinctive aluminium hexagonal honeycomb based heat transfer enhancements (HTE) having higher surface area to volume ratio for effective heat transfer combined with low system weight addition. The system performance was studied under different operating conditions. The optimum absorption condition was achieved at 35 bar with water at room temperature as heat transfer fluid where up to 90% absorption was completed in 7200 s. The performance of the reactor was observed to significantly improve upon the addition of the HTE network at a minimal system weight penalty.     

降低G级油井水泥初始稠度的控制措施

通过优化油井水泥熟料、油井水泥粉磨工艺、控制比表面积、SO3含量，有效降低油井水泥初始稠度。通过对水泥成品存储条件和存储时间的研究，确定了适宜的水泥出厂时间及后续工地的储存条件，保证了产品使用满足工地需求。     

A Hybrid Virtual Cloud Learning Model during the COVID-19 Pandemic

The COVID-19 pandemic has affected the educational systems worldwide, leading to the near-total closures of schools, universities, and colleges. Universities need to adapt to changes to face this crisis without negatively affecting students’ performance. Accordingly, the purpose of this study is to identify and help solve to critical challenges and factors that influence the e-learning system for Computer Maintenance courses during the COVID-19 pandemic. The paper examines the effect of a hybrid modeling approach that uses Cloud Computing Services (CCS) and Virtual Reality (VR) in a Virtual Cloud Learning Environment (VCLE) system. The VCLE system provides students with various utilities and educational services such as presentation slides/text, data sharing, assignments, quizzes/tests, and chatrooms. In addition, learning through VR enables the students to simulate physical presence, and they respond well to VR environments that are closer to reality as they feel that they are an integral part of the environment. Also, the research presents a rubric assessment that the students can use to reflect on the skills they used during the course. The research findings offer useful suggestions for enabling students to become acquainted with the proposed system’s usage, especially during the COVID-19 pandemic, and for improving student achievement more than the traditional methods of learning.     

Improvement of the quality stability of vacuum-packaged fermented fish (Suanyu) stored at room temperature by irradiation and thermal treatments

To evaluate the effects of irradiation and thermal treatments on the quality characteristics of the vacuum-packaged low-salted fermented fish (Suanyu) during 90-day storage, thermal-treated group (TTG), irradiated-treated group (ITG) and non-treated group (CG) were prepared. The results showed that total viable counts reduced by 4.49 and 4.67 log CFU/g after thermal and irradiation treatments, respectively, and no coliforms and pseudomonas growth occurred during storage. Compared with CG, lower levels in L*, springiness, chewiness of TTG and higher levels in L*, b* and chewiness of ITG were detected after 90-day storage. Total biogenic amines content was significantly reduced in ITG compared with CG and TTG (P < 0.05). Both irradiation and thermal treatments have the potential to maintain quality of Suanyu during room storage. Compared with irradiation, thermal treatment could better stabilise the free amino acids and volatile compounds of Suanyu during room storage, but had some negative effects on texture quality.     

基于DSP的多元数据同步采集与存储系统的设计与实现

从硬件和软件两个角度出发,介绍基于DSP的多元数据同步采集与存储系统的组成、工作模式以及功能的测试。系统主要由上位机和数字采集与存储单元组成,其中数字采集与存储单元的硬件部分包括电源模块,值班电路模块,数据采集模块,数据存储模块,时钟同步模块。系统采用DSP作为中央处理芯片,利用经过同步后的秒脉冲作为触发信号,实现同步数据采集。以CF卡作为存储介质,实现数据自容式存储。软件部分实现自检、同步、数据采集存储功能。经过测试,系统工作稳定,功能正常,同步精度在100ns以内。     

On Cost Aware Cloudlet Placement for Mobile Edge Computing

As accessing computing resources from the remote cloud inherently incurs high end-to-end (E2E) delay for mobile users, cloudlets, which are deployed at the edge of a network, can potentially mitigate this problem. Although some research works focus on allocating workloads among cloudlets, the cloudlet placement aiming to minimize the deployment cost (i.e., consisting of both the cloudlet cost and average E2E delay cost) has not been addressed effectively so far. The locations and number of cloudlets have a crucial impact on both the cloudlet cost in the network and average E2E delay of users. Therefore, in this paper, we propose the Cost Aware cloudlet PlAcement in moBiLe Edge computing (CAPABLE) strategy, where both the cloudlet cost and average E2E delay are considered in the cloudlet placement. To solve this problem, a Lagrangian heuristic algorithm is developed to achieve the suboptimal solution. After cloudlets are placed in the network, we also design a workload allocation scheme to minimize the E2E delay between users and their cloudlets by considering the user mobility. The performance of CAPABLE has been validated by extensive simulations.      

浊点萃取在锕系和镧系元素分离分析中的应用

浊点萃取（cloud point extraction, CPE）是一种安全环保同时兼具高富集系数和低成本的萃取方法，在分析化学中已经被广泛应用于金属离子分析等领域。锕系和镧系金属元素存在环境复杂，自身浓度相对较低，对其进行分离和分析一直是放射化学研究者所关注的问题。经过条件优化，CPE能够有选择性地分离和富集锕系和镧系金属元素。通过与多种技术联用，CPE能实现锕系和镧系元素的高灵敏度分析。本文在介绍浊点萃取机理的基础上，着重描述了不同萃取体系中各类萃取剂（β-二酮类、膦氧类、含氮类、含硫类）对于锕系和镧系元素的萃取效果，全面总结了其中使用的不同联用技术，同时简述了通过构筑超分子识别位点，修饰配体，使用不同表面活性剂及掩蔽剂等改良现有浊点萃取体系的尝试。最后，对浊点萃取在放射化学领域的应用进行了总结和展望。     

Enhancement of energy storage density in antiferroelectric PbZrO3 films via the incorporation of gold nanoparticles

In this work, antiferroelectric Au–PbZrO₃ (Au–PZO) nanocomposite thin films were prepared by chemical solution deposition (CSD), and the effects of Au concentration on the antiferroelectric properties and the recoverable energy density were investigated. The results showed that the optimal Au concentration in the Au–PZO nanocomposite thin films was about 1 mol% for structural and electric properties. In the Au–PZO nanocomposite thin films with 1 mol% Au, Au nanoparticles (NPs) were distributed uniformly in the perovskite PZO matrix. Moreover, the recoverable energy density was 10.8 J/cm³ at 600 kV/cm, which is 42% higher than that of the pure PZO films. The results demonstrate that adding an appropriate amount of noble metal NPs in antiferroelectric thin films is an effective method to improve the energy storage properties.